![]() The chipped end will be cut off to fit the width I need, so it worked out perfectly! it just happened to be the exact depth I needed, so I took it apart and salvaged the top, bottom and two shelves. One of the things I unearthed from that mess was this cheap, broken bookcase. Remember that the stud finder tells you where the edges of the stud are, so test from both sides and place the tape in the middle. Mark each stud with painter's tape, and take note of the locations so you can predrill holes in the brackets later on. I was thrilled to discover that there were studs exactly where I needed them! If you don't have a stud on one wall, you'll need to use drywall anchors to hold the shelf brackets in place securely. Use a stud finder to locate the studs in the walls on all three sides. There was trim around the inside of the closet door, so I also measured from the side wall to the trim. I measured the width of the wall from front to back in several places (since walls are rarely perfectly straight). Don't worry, I made sure the spacing was even when I finally installed them! ![]() ![]() I just eyeballed the spacing and decided to make four shelves. Using strips of painter's tape, I marked roughly where I wanted the shelves above the air conditioner to be. I wanted a spot for our portable air conditioner, and it fit perfectly in the recessed side of the closet. Consider what you plan to store inside before you start building. Now I could measure the interior available space and decide how many shelves I needed. I'm amazed this thing could hold any weight at all! That's some quality craftsmanship right there. We don't need that much hanging space, so I removed one of the rods. This small closet had two rods extending front to back, rather than side to side. How to Build Closet Shelves Measure your space
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |